Scott Brooks 345 Chase Avenue Hamilton, OH (513)887-7527 (513)371-4989
Objective:A challenging career as an Electrician.
Experience:Servall Electric CompanyGlendale, OH Foreman Electrician11/2006 to 4/2008 Planned layout of wiring and installed wiring, conduit and electrical apparatuses in buildings. Planned wiring and installation of equipment and fixtures, such as motors, generators, switches, circuit breakers and fuse boxes, according to blueprints, schematic drawings and sketches. Inspected wiring and fixtures for conformance to company specifications and local electrical codes, using test equipment, such as voltmeter and ohmmeter. Interpreted specifications, blueprints and job orders to workers and assigned duties. Planned new and modified installations to minimize waste of materials, provide access for future maintenance and avoid unsightly, hazardous and unreliable wiring, consistent with specifications and local electrical codes. Measured, cut, bent, threaded, assembled and installed electrical conduit, using tools such as hacksaw, pipe threader and conduit bender. Pulled wiring through conduit, assisted by electrician assistant, to install and repair electrical wiring, fixtures and equipment. Installed and supervised the installation of low voltage intercom entry systems in multi unit apartment complex's. Maintained company vehicle.
Digital DishMillersburg, OH Satellite Technician6/2003 to 8/2006 Installed tests and repaired antennae and related equipment that received communication satellite signals. Reviewed installation specifications, building permits, manufacturer's instructions and government ordinances to determine installation site for antennae. Visually inspected installation sites to identify obstructions, such as trees and buildings that could distort or block microwave signals from satellite. Discussed site location and construction requirements with customers. Climbed ladder to install antennae when areas were inaccessible from ground. Attached antenna to base, using nuts, bolts and hand tools. Connected antenna and television set to signal converter control box. Tested installed system for conformance to specifications, using test equipment such as multimeters and oscilloscope. Observed picture on television screen to evaluate reception. Replaced and repaired defective parts. Constructed pole and roof mounts for antenna base, using carpenter's tools. Maintained company vehicle.
Bill Spade Heating/air & Electric CO.Cincinnati, OH Electrician5/2002 to 5/2003 Planned layout, installed and repaired wiring, electrical fixtures, apparatuses and control equipment. Planned new and modified installations to minimize waste of materials, provide access for future maintenance and avoid unsightly, hazardous and unreliable wiring, consistent with specifications and local electrical codes. Gathered tools and supplies to be used at work site. Measured, cut and bent wire and conduit, using ruler and hand tools. Drilled holes for wiring with power drill and pulled or pushed wiring through opening. Traced out short circuits in wiring, using knowledge of wiring and test meter. Maintained tools and equipment and kept supplies and parts in order. Maintained company vehicle.
Stoutenborough Electric CO.Middletown, OH Electrician Apprentice6/1998 to 3/2002 Drilled holes for wiring with power drill and pulled and pushed wiring through opening. Helped measure, cut, bend, thread, assemble and install electrical conduit. Pulled wiring through conduit. Gathered tools and supplies to be used at work site, according to instructions. Helped trace out short circuits in wiring. Helped repair faulty equipment and systems.
Education:I.E.C. (independent electrical contractors of greater Cincinnati)Cincinnati, OH 2 yrs electrical apprenticeship school1998/1999
Hamilton High Career CenterHamilton, OH 2 yrs Machine Trades1996/1997
Hamilton High SchoolHamilton, OH Diploma1997
References:Available upon request
|